Response Rate Limiting

このページは、まだ日本語ではご利用いただけません。翻訳中です。

Looking for the plugin's configuration parameters? You can find them in the Response Rate Limiting configuration reference doc.

This plugin allows you to limit the number of requests a developer can make based on a custom response header returned by the upstream service. You can arbitrarily set as many rate limiting objects (or quotas) as you want and instruct Kong to increase or decrease them by any number of units. Each custom rate limiting object can limit the inbound requests per seconds, minutes, hours, days, months, or years.

If the underlying service or route has no authentication layer, the Client IP address is used. Otherwise, the consumer is used if an authentication plugin has been configured.

Configuring quotas

After adding the plugin, you can increment the configured limits by adding the following response header:

Header-Name: Limit=Value [,Limit=Value]

Because X-Kong-Limit is the default header name (you can optionally change it), the request looks like:

curl -v -H 'X-Kong-Limit: limitname1=2, limitname2=4'

The above example increments the limit limitname1 by 2 units, and limitname2 by 4 units.

You can optionally increment more than one limit with comma-separated entries. The header is removed before returning the response to the original client.

Headers sent to the client

When the plugin is enabled, Kong sends some additional headers back to the client telling how many units are available and how many are allowed.

For example, if you created a limit/quota called “Videos” with a per-minute limit:

X-RateLimit-Limit-Videos-Minute: 10
X-RateLimit-Remaining-Videos-Minute: 9

If more than one limit value is being set, it returns a combination of more time limits:

X-RateLimit-Limit-Videos-Second: 5
X-RateLimit-Remaining-Videos-Second: 5
X-RateLimit-Limit-Videos-Minute: 10
X-RateLimit-Remaining-Videos-Minute: 10

If any of the limits configured is being reached, the plugin returns an HTTP/1.1 429 (Too Many Requests) status code and an empty response body.

Upstream headers

The plugin appends the usage headers for each limit before proxying it to the upstream service, so that you can properly refuse to process the request if there are no more limits remaining. The headers are in the form of X-RateLimit-Remaining-{limit_name}, for example:

X-RateLimit-Remaining-Videos: 3
X-RateLimit-Remaining-Images: 0